[C_5]

i need help foe immo off ecu P56041 motorola .
someone of you has already immo off these ecu motorola? which eprom should I read?
this ecu have frlasch AB28F200 and motorola SC418371MFU4.
i tried to read SC418371MFU4 as HC11K4 but i cant read it

[pandokrator]

immo is on hc11
0x012~0x015 FFFF00FF
unplug alarm box and add start signal direct to starter motor.

[darek_naprawa]

Raise tx rx and reset.

---

immo is on hc11
0x012~0x015 FFFF00FF
unplug alarm box and add start signal direct to starter motor.

Can you explain .

[pandokrator]

Raise tx rx and reset.

---

immo is on hc11
0x012~0x015 FFFF00FF
unplug alarm box and add start signal direct to starter motor.

Can you explain .

what you need i explain ?
1)read hc11
2)in address 00000012 change 4 bytes with FF FF 00 FF
3)unplug key coil and if car have alarm system need unplug too
4)now need add start signal direct to start motor
bR

[immokill]

Mate ypu must read HC11 and post file here if you dont understand where you need to put
4 bytes to start car

I already test immo off on hc11 ecu and work like charm. This ecu opens like a book ?
if yes post HC11 no need to raise pins good programmer will read it

Regards