Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Help Esys flashing G05 ACSM EGS RAM failed
12-10-2023, 06:42 AM,
Post: #1
|
|||
|
|||
Help Esys flashing G05 ACSM EGS RAM failed
Hello,
I flashed a G05. First I wanted to do an Update with ISTA but ISTA wanted that I change some ECUs so I switched to Esys. What I did: ICOM OEM connected to router, start Esys Read FA, Read SVT-IST (ECU), calculate SVT-SOLL HW from SVT-IST Calculate TAL. Everthing went good except EGS RAM and ACSM. EGS is online but ACSM and RAM offline. I tried Flexray sync and Battery reset but I cant flash EGS. So tried again with ISTA but even ISTA cant programm EGS. Maybe someone can help me or had the same issue that I have. I also ready to pay for help because many experts dont have much time and time is money |
|||
12-10-2023, 07:58 AM,
Post: #2
|
|||
|
|||
RE: Help Esys flashing G05 ACSM EGS RAM failed
(12-10-2023, 06:42 AM)Enforc3r Wrote: Hello, Have you tried programming the control devices using the TAL calculation? What information do you get when you perform a new SVT and TAL calculation? |
|||
12-10-2023, 09:28 AM,
Post: #3
|
|||
|
|||
RE: Help Esys flashing G05 ACSM EGS RAM failed
when calculating new svt and Tal its say hwinstall for ACSM and RAM for EGS just flashing bl etc but when i try to Flash egs i get error after around 10%
|
|||
12-10-2023, 09:41 AM,
(This post was last modified: 12-10-2023, 10:14 AM by Node.)
Post: #4
|
|||
|
|||
RE: Help Esys flashing G05 ACSM EGS RAM failed
So you are trying to flash a CLEARLY incompatible firmware. What ELSE do you expect? And of course you just press HW-IDs from actual because it's the MAGIC button (or you are just ignoring HW actions in TAL which is another MAGIC way).
P.S. You should provide your FA and SVT-ist files here. |
|||
14-10-2023, 14:52 PM,
Post: #5
|
|||
|
|||
RE: Help Esys flashing G05 ACSM EGS RAM failed
@node
Thank you for your answer, we figuerd out what the problem is. This is g05 is s pre production car where the enegeniers from BMW Tested the car and done some Programming so there was a Special can controller installed. Even when I changed the Hardware to TAL it would fail. |
|||
14-10-2023, 16:57 PM,
Post: #6
|
|||
|
|||
RE: Help Esys flashing G05 ACSM EGS RAM failed
Please show some pictures of this special can controller. Would be interesting to see.
| BimmerFiks AS | Instagram | |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content