Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
EDC17c42 Ktag read problem
24-10-2023, 21:47 PM,
Post: #1
|
|||
|
|||
EDC17c42 Ktag read problem
I have problem read edc17c42 renault ecu with clone ktag, comunication error. Ktag is eu version red PCB. I havent too much EDC17 ecu to read, does galleto v54 clone work with this ecu, if yes I will buy and rework ktag after that bacause edc16 read ok.
Best regards |
|||
25-10-2023, 07:00 AM,
Post: #2
|
|||
|
|||
RE: EDC17c42 Ktag read problem
Hello.
I do it with Kess clone, read/write no problem. |
|||
25-10-2023, 08:30 AM,
Post: #3
|
|||
|
|||
RE: EDC17c42 Ktag read problem
|
|||
25-10-2023, 09:27 AM,
Post: #4
|
|||
|
|||
RE: EDC17c42 Ktag read problem
According from other websites, KTAG clone can do it.
Double check your connexion and your power supply. |
|||
25-10-2023, 19:37 PM,
Post: #5
|
|||
|
|||
RE: EDC17c42 Ktag read problem
I will check again, first I try with probe pin for boot mode and after that solder to pin, same. I use direct connection. Power led on ktag blink power consume more than 1A, 13V
Best regards |
|||
01-11-2023, 22:26 PM,
Post: #6
|
|||
|
|||
RE: EDC17c42 Ktag read problem
galisdoo dateline='[url=tel:1698262627' Wrote: 1698262627[/url]'] I solder boot pin and cnf1 on chip and work ok read and write. Best regards |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content