[ahmadarifai]

I need to add key to Bentley 2014 with continental kessy.

is it possible to read kessy with vvdi prog in circuit and use vvdi2 to add key? 

I read somewhere it is encrypted and i will not get the correct PIN and CS.

appreciate the help

[raffy haddad]

With vvdiprog and vvdi2 will be ok
but must read with vvdi prog in circuit as diagram and load to vvdi2
regards

[ahmadarifai]

Thank you Raffy for your reply i did read it in circuit and the pin and cs seems to be wrong when i put in vvdi2 because cannot add key should i remove 93c86

[raffy haddad]

No desolder load dump in vvdi2  , key learn , 4th immo , vw touareg audia8 porshe cayenne bently and you get pin cs ( choose get component protection from kessy read by vvdi prog 
Then make dealer key with 7th byte cs and learn to car with pincode
regards
post file read here

[ahmadarifai]

I did exactly what you said above.

i attached the dumps

[raffy haddad]

For me the file size is not good 2kb vvdiprog must read 2.25kb
check your soldering andreread till you get 2.25kb
or someone else will help you with this 2kb read

[ahmadarifai]

I appreciate your help Bro, can you tell me which option should i use in vvdi prog? in photo there are two last and before last. thanks mate.

[raffy haddad]

Kessy 2008-weld
is the eeprom c86 ?
Use weld picture and conect 12v
To vvdiprog

[ahmadarifai]

i used the other one maybe that was the issue, Read write backup

yes it is 93c86.

i will try

[ahmadarifai]

Thank you Raffy, you are right i read it again and its 2.25KB and gave correct CS and PIN and worked.