[David.D]

Hello my range rover hse diesel 2007 wont start after cluster swap. Orignal in car but still Red light on dash and the warning hazard blinks and nothing more. I have a autel elite and there is error on cluster,rdc,transmission and all of them something with software lost or not compatible. I tried to find programin in my tool but cant find in this tool. Is it something I can do to fix this.

[liviu2004]

Very little information you provide. Where is the autel report? Where are the engine details?

[David.D]

Hi here is all the errors

[AutoLocks67]

You need to explain bit more.

1.Did Vehicle run before Swapping Cluster
2. Why did you change in the first place.
2. Did you attempt to program/code when donor Cluster fitted?
3. What have you done upto this point? Programming/Coding etc?
4. Is the Replacement Part compatible. Same Part No?

More Info you give more help you are likely to get.

[David.D]

You need to explain bit more.

1.Did Vehicle run before Swapping Cluster
2. Why did you change in the first place.
2. Did you attempt to program/code when donor Cluster fitted?
3. What have you done upto this point? Programming/Coding etc?
4. Is the Replacement Part compatible. Same Part No?

More Info you give more help you are likely to get.

Hello , only swap cluster but higher version with bigger lcd in middle. But put Back original and car wont start. 
When I choose programing in autel maxysis elite i only have some options but I cant program ecu transmission or cluster . There is no option

[AutoLocks67]

It looks like you have numerous Network communication faults also
Can you check none of the pins have been bent on the original Cluster causing can bus
faults. I suspect the software faults are because you have fitted Cluster with incorrect software levels.

Delete all Faults Attempt start & Rescan. Please post results.

So vehicle was running ok before the Cluster swap?

[David.D]

Car was running yes .all pin is good in cluster. And the errors is after erase. So like i said just swap cluster . New cluster didn not work . After i swap back to original an car wont start. Erase error and this is what it is left. All the errors you see its what can't be erased. Car immo light is ON and only the warning hazard is on ( all 4 turn signals and also in cluster.

---

Very little information you provide. Where is the autel report? Where are the engine details?

People with JLR knowledge dont need so much information. I explaind what I did. And I think that is enough to know what the problem is for them. )))

[AutoLocks67]

You are going to need SDD to Run scan and complete necessary fix/updates.
Then run immobilisation to re-sync all modules.

I would also suggest that the More info you give will benefit the help you receive.
You will get more accurate information relating to the fault.

You are insulting people for having little knowledge but you have made this problem
because you have little knowledge. Not polite way to ask for help.