[harris_r]

Hi everyone!!!I try to program a new key in Opel corsa c with opcom and the car will not start !!if you put the old key and the new post the car started but once it off and left it shortly after the retry the car will not start !! Anybody know me exactly procedure how to do it ?? if gets ??? ihave ck-100 , mini zed bull, carprog, opcom!! thanks alot!!!!!

[Okino]

OPCOM
Diagnostics>
Year>
Car>
Body>
Immobiliser>
Programming>
Immobiliser Programming>
Security Code> Enter the code>OK
Program Transponder keys>
Yes>
Once programming is complete you will get a confirmation
message. Now do a global scan of all modules and clear all DTC codes.
Close down the software and disconnect the interface. Turn
ignition off for 1 minute then try to start your car. Make sure both
keys work. If not program again.

[harris_r]

OPCOM
Diagnostics>
Year>
Car>
Body>
Immobiliser>
Programming>
Immobiliser Programming>
Security Code> Enter the code>OK
Program Transponder keys>
Yes>
Once programming is complete you will get a confirmation
message. Now do a global scan of all modules and clear all DTC codes.
Close down the software and disconnect the interface. Turn
ignition off for 1 minute then try to start your car. Make sure both
keys work. If not program again.

I did BUT AGAIN NOT START THE CAR ! If you placed the previously programmed keys and started and put IMMEDIATELY AFTER THE unscheduled KEY STARTS BUT IF it off and left it 10 SECONDS THERE WORKS AGAIN !! WHO DO WRONG ????

[rs@chip]

I have the same proplem on vectra c..I cant program new(old) key..I checked with zedbull and transponder status is locked..someone now how to unlock transponder or need to buy new one?

[harris_r]

HI EVERYONE!!!I HAVE A GOLF MODEL 2001 AND I WANT TO PROGRAM NEW KEY.. CODE PIN I HAVE,, TO DO WITH THE PROCEDURE CK-100 but the car will not start !! DOES ANYONE KNOW THE EXACT PROCESS DOES SOMEWHERE DO WRONG ???? THANK YOU !!!!

[rs@chip]

Which golf?which ecu?you can do it with vag k+can or vcds..etc lot of tool can slove this if you have pin

[callillo]

Hi Dears.
You are trying programm old keys. You need programm new keys in these models. If you have the correct pin code and erase all keys first, you can reprogramm the old key that was in use before the erasing, but the key that you want add, must be allways new.

Regards

[rs@chip]

I slove this on vectra c and corsa d with old keys but you need erase all transponders, reset cim and then adapt new(old key)