Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
PSA EDC17C60 possibile with KTAG?
18-02-2024, 20:15 PM,
(This post was last modified: 18-02-2024, 20:28 PM by Dawid_97.)
Post: #1
|
|||
|
|||
PSA EDC17C60 possibile with KTAG?
Hello mates,
I have an bosch edc17C60 ecu, need to delete SCR on it. But when i checked protocols on my clone, it looks like is an older type of ecu. Is this safe to read and write with this protocol this control unit? Does anyone can help me? Best regards ECU number in ktag 0 281 031 043 my ECU number is 0 281 032 456 |
|||
18-02-2024, 20:19 PM,
Post: #2
|
|||
|
|||
RE: PSA EDC17C60 possibile with KTAG?
It's possible, I have ktag clone with 2.23 software, I was able to read / write using gpt cable and connection
|
|||
18-02-2024, 20:29 PM,
Post: #3
|
|||
|
|||
RE: PSA EDC17C60 possibile with KTAG?
Dont forget about tprot
|
|||
18-02-2024, 20:34 PM,
Post: #4
|
|||
|
|||
RE: PSA EDC17C60 possibile with KTAG?
ktag took care of the Tprot for me but better to be safe than sorry
|
|||
Reputation: +1 - sivyx [+1] | |||
18-02-2024, 21:01 PM,
Post: #5
|
|||
|
|||
RE: PSA EDC17C60 possibile with KTAG?
(18-02-2024, 20:29 PM)sivyx Wrote: Dont forget about tprot What are the steps for Tprot? SW shows connetor cable and GPT cable It says that i should connect gray cable with clip to boot mode, with is 6'th pin of bga controller, and rest of cables to main main connector pin. This will work or i should do some other steps? Sorry but it's my second controller that i try to read and I don't wanna brick anything. |
|||
18-02-2024, 21:11 PM,
Post: #6
|
|||
|
|||
RE: PSA EDC17C60 possibile with KTAG?
this will help with tprot, do you have gpt cable ?
|