[Dayo]

Can this be done with digi? If so, what chip?

Thanks

[pietje001]

Digiprog can do it.
chip 93c66

[Dayo]

Ok thanks mate.

Is the chip on the back or is it a full strip?

[pietje001]

Am not sure, i think not on the back.so then you would need to remove the needles

[Clusters]

Ok thanks mate.

Is the chip on the back or is it a full strip?

Most Toyotas have programming pads on the back, all the same 123485, use ST47 and connect according to this Enigma pdf NUMBERS not colors.

Conversion chart for ST 47 to Enigma and others.

[Dayo]

What option do i use on digi to read it? Iv never done a st47 conversion before

[Clusters]

What option do i use on digi to read it? Iv never done a st47 conversion before

Use Eeprom menu, save a copy, edit manually.

Never used ST47? Make sure you have it wired correctly with the right color wires.

[Dayo]

Set it as 93c66 eeprom?

---

Where have you got your calcs from? Tachosoft?

[Clusters]

Set it as 93c66 eeprom?

---

Where have you got your calcs from? Tachosoft?

Tachosoft calcs work OK, but if not done right it will not count up on odometer.

I use this on earlier ones and do it with windows hex calculator. Have to see the 2012 dump to know for sure.

Edit, just looked at 2015 dump, same algo.

[mike101]

Ok thanks mate.

Is the chip on the back or is it a full strip?

Most Toyotas have programming pads on the back, all the same 123485, use ST47 and connect according to this Enigma pdf NUMBERS not colors.

Conversion chart for ST 47 to Enigma and others.

Sorry for the thread hijack - will this work with the similar programming pads on the back of Honda and Nissan dashboards as well?