[Macman07]

Hello,
I have tested to change the kilometers on the dash of a VW golf IV tdi 2000 with my digiprog3 clone v4.94 by obd. But whitout any results.
He dont read me the old km, he give me an "?". Anyway, I write the new kilometeres, and he say me test 0, test 1 etc.., and "wegfahrspeere kodieren 0x00".
Does anyone knows what I have to do here??

I pressed "X", and I have waited so much time, so i've cut the digiprog alimentation.
The kilometers on the dashboard displayed the old. But all is ok with the dashboard and car, everything works well whew.

Of course, in the process, the ingnition was on!

I've never seen something like this doing a VW with Digiprog, so if somenone could help me, it would be very cool!!

Thanks in advance!

Best regards

[pietje001]

I've seen it.. just press 'V' it will work.

it;s normal for this car it doesnt read old mileage.
sometimes it neccacery to disconnect battery after mileage change.

[Macman07]

Thank you for your answer!
But, i have seen on internet that this code, asked by the digiprog, is about the immo or something like that..
Are you sure that i dont risk anything by pressing V without put a code?
Sorry for.my bad english...
Thanks a lot!

[pietje001]

Did it ask to enter a code? or can you only press 'v' or 'x'?
do you have a photo?

[Macman07]

I didn't have photo...
In fact, the digiprog open a little window with something like that :
"Code -> 0xFFFF=back to the beginning" -> I'm not sure of the exact message
"0x "
And after this "0x", i can do what i want (enter something, or just "V" or "X")
But i don't know if i have to enter a code or not...
There is my problem.

[pietje001]

I also had it, but can't remember I could enter a code.
anyway I pressed 'v' and it was okay. but I cant give you any quarantee it will be the same at your car.

hope some one else has info about it.

[Macman07]

Ok, so i think i'm gone wait for other advise, if someone else have seen this problem...
Thank you pietje001

[pietje001]

Maybe you can use another tool? (but don't use super vag on this car!)

[Macman07]

Hi,
Just for information, i've tried just pressing 'V' and it doesn't work...
No problem on the car, but the digiprog don't change the mileage.
bye

[dorofteius]

It's searching pin by brute force. You have to let-it do his job.
Sometimes it takes almos 1 hour.
This happens with MM dash.