[luci.deresu]

Hello.

I know that some people had problems with configuring ICOM-P Next to programming and diagnose. This knowledge will definitely be useful to someone, I have several dozen ICOM-P Next units from the factory and I finally managed to run them so that I can freely diagnose, code and program them using ISTA/E-sys.

ICOM-P NEXT with this configuration works in the same way as ICOM NEXT, only via a LAN cable. It cannot be configured via WIFI because ICOM-P has blocked ports to the administration panel. If you want to use ISTA, you need to set it to use EDIABAS settings as in the photo below.

After all steps, you don't have to do anything Itoolradar (Besides, he is invisible in it.). ICOM is ready to use.

Step 1 - Restore ICOM-P to factory settings via USB (attaching below):

(Copy „ICOM_Restore.bin“ to the root of the usb-stick (USB 2.0 and formatted with FAT32) and
connect it to the USB-Port of the ICOM P
2. remove LAN-connector (RJ45) if it is connected to the ICOM P!!!
3. press the reset button (little hole neare the USB-sockert)
4. put the ICOM P on power and wait till all leds turn to solid red
5. press reset button 3 times in max. 5 seconds →all leds turn to flashing red

Step 2 - Configure your network card on your computer system with the following settings:

IP ADDRESS:  192.168.68.38
SUBNET MASK:  255.255.255.0

Step 3 - Change in EDIABAS.INI:

Interface        = RPLUS:ICOM_P

Step 4 - Change in RPLUS.ini:

[ICOM_P]
REMOTEHOST = 192.168.68.40

[LAN]
REMOTEHOST = 192.168.68.40

--------------------

Enjoy

Are you willing to sell 1 piece?