[Jancss]

I read and compare with original dump, in 3 places values is changed, all rest dump is the same. Think maybe is not correct than in ori dump appears just 3 groups of 2 bits... think need be 4(marked with red colour). Solder back and connect, nothing changed as before.Car wont start.


Maybe, please,  make correction from your side from ori file and check again if ori km is correct 265320.
New need 168000km

Thanks

[tigre]

your edit is good

try disconect batterie, check dtcs

[Clusters]

Your correction is 100% good, original verified as 265320

[Jancss]

1732658561[/url]']
your edit is good

try disconect batterie, check dtcs

Before remove BCM the battery was disconnected. Errors or dtcs that appear can be seen above in the pictures.
Yesterday car start and run without problems, after bmc removal appears problems(central lock not work, car won't start, no km value in dashboard and so on...)

[al70]

1732658561[/url]']
your edit is good

try disconect batterie, check dtcs

Before remove BCM the battery was disconnected. Errors or dtcs that appear can be seen above in the pictures.
Yesterday car start and run without problems, after bmc removal appears problems(central lock not work, car won't start, no km value in dashboard and so on...)

Are you sure you're soldering eeprom back the correct way round ?

---

I always take a photo of a PCB before I remove an eeprom to make sure I'm putting it back in the correct position

[Jancss]

Today put bcm back and voila all work, think problem was in bad eeprom soldering in pcb, thanks all for help!