[BMWF01]

I just programmed my DME along with CAS unit.

i ordered both from the dealer, but the DME shows "global unknown" with a red x inside ista-p.

The coding also failed !

The CAS module programmed & Coded Ok with a green tick.

does this means my BMW e60 won't start?


i have same problem too

[inspi1981]

At DME in Channel You have CD-DVD-Drive. So ISTA-P don't make update. No idea what that mean

[lynxbmw]

Run ista-d and see if it can communicate with LM and KOMBI.
Go back and do second try with ista-p.
You should of mark DME as replaced ecu, have you also replaced your CCC?
BTW is this 14.83 real voltage ? it seem high to me.

[BMWF01]

At DME in Channel You have CD-DVD-Drive. So ISTA-P don't make update. No idea what that mean

I don't know how that channel has CD-/-DVD in it Bro, i am clueless.

I am gonna do it over and select DME as replacement and let you all know.

---

Run ista-d and see if it can communicate with LM and KOMBI.
Go back and do second try with ista-p.
You should of mark DME as replaced ecu, have you also replaced your CCC?
BTW is this 14.83 real voltage ? it seem high to me.

The Voltage is really showing 14.63 volts Brother, just zoom in the picture to see it.

ISTA-D communicates with LM & KOMBI
KOMBI WAS PROGRAMMED BUT NOT CODED via ISTA-P 3.56.005
LM Module was later programmed by me using Winkfp 5.3.1 - I will treat it later with ISTA-P to CODE it and update it to reflect latest i-level using ISTA-P 3.56.005

Thanks for your inputs though.

best regards.

[bimmer71]

The channel of programmed unit dme cd dvd drive something up with what software you using, do you have icom if so redo with it no replacement just make sure you do a complete coding