[mista]

Hi guys i need to know which hardware it s better for me to program a id 48 megamos crypto for fiat punto 1.2 2004

thanx for help

[djole3113]

You can first read dump from delphi bsi with upa,xprog etc. Than you can precode transponder for obd programming or programm transponder which will directly start the car-for this operation you can use zed bull(clone or original). Or you can do all the job via obd with zed full or abritus.

[mista]

Thanx a lot for help my friend can you tell me with wich software do you use with zed bull? i have already pincode to program the transponder can in program manually with zed bull?

which zed bull can you advice me ? thanx a lot

[djole3113]

I use original zed bull.But you can finish the job with clone device as well. There is an option to make transponder directly without obd progarmming,you can see that in zed bull soft

[mista]

Ok if i understand i can write the pin directly with zed bull software witout to extract dump from bsi
can you advice me about zed bull original where can i buy it
did you listen positif comment about writting id 48 with zed bull clone

thanx a lot for help

[tronico]

Ok if i understand i can write the pin directly with zed bull software witout to extract dump from bsi
can you advice me about zed bull original where can i buy it
did you listen positif comment about writting id 48 with zed bull clone

thanx a lot for help

No, pincode itself isn't enough. You can make a precoded key only from the BCM (bsi) dump. Pin code is only for key teaching (with diag tool), if You don't write back the new key data directly to BCM eprom.
You can find original ZedBull distributors in attachment link.

br, tronico

[mista]

Can you give me some idea about key teaching with diag tool for punto ?

thanx a lot

[mista]

Hi guys please who can explain me the différence between precoding and pin code
To program a id 48 do i need a unlocked transpondeur?
Thanx d'or help

[djole3113]

Mate,looks like you need basic knowledge about key programming,it is not easy to explain in only one post. Precoding is transponder related process which prepare transponder by dump data for obd programming. Pin code(personal identification number) allowed entering in key programming.
And yes,you need virgin(not previously programmed) transponder for this operation.

[mista]

So if i understand if i order a transponder from net i need to precoded before to program it with pincode ?

because the problem i have a original transponder defect but it s the only one i m not sure i can read it again
thanx a lot for help