[vilord]

Any suggestions of how to bring carplay back? Any ideas why the OABR ethernet diag port isn't working?


Here are the steps I've gone through:

- Purchased used Evo from wrecked F82. Previous owner had purchased the official Carplay connected drive update.
- Tested carplay, liked it.
- Flashed Evo to 2018-07
- Updated Evo VIN to match my ATM
- Installed a retrofit FSC set
- Flashed the ATM to 2018-07
- Tested ATM connectivity. Success.
- Tested Carplay. Success.
- Put Evo on a shelf for 2 weeks while dealing with work backlog
- Wired up and installed L7 amp and speakers (car was HiFi)
- Put Evo, emulator (one of Adrian's), ATM, touch knob and touch module into car
- Carplay is gone.
- Tried to connect to Evo, ethernet port seems to cycle connected/disconnected every 2 seconds.
- Connected ZGW and coded Evo through KCAN2
- Evo ethernet port still cycling connected/disconnected
- Carplay is still not there.

Here's the current VO: 1CA,1CB, 21T,248,2VB, 302,319,322,387,3AG, 423,430,431,459,465,488,490,493,494,4AE,4WL, 502,508,521,522,524,534,544,563,575,5DS, 609,645,655,688,697,6AC,6AE,6AK,6AM,6AP,6CP,6NR,6NS, 760,775,7M9,7MA, 823,845,853,8KL,8R9,8S4,8TN, 925,992,993,9AA

Below is the results of running GetStatus on the Evo's FSCs.

--> GetStatus
<--
RootCertStatus not available
SWSigStatus not available
SWTApplications
<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 158(0x9E)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 160(0xA0)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus rejected
AppNr./UpgrIdx 368(0x170)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 111(0x6F)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 159(0x9F)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 156(0x9C)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 229(0xE5)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 289(0x121)/42(0x2A)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 323(0x143)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 366(0x16E)/1(0x01)
SWTType SWTclassic light

<--
FSCSCertStatus not available
FSCStatus accepted
AppNr./UpgrIdx 367(0x16F)/1(0x01)
SWTType SWTclassic light

RoutineResult: OK
<-- ok

[alblue]

Is not because ATM is F 25's?
I think that it is necessary for ATM of donor HU.

The ampere is low, and it has become the same phenomenon.

[vilord]

Figured it out with Donald's help. The 2CP wasn't applying properly with my voice type and date code.
When I manually turned on the carplay options and rebooted, it worked

[thstorm]

Figured it out with Donald's help. The 2CP wasn't applying properly with my voice type and date code.
When I manually turned on the carplay options and rebooted, it worked

Can you write the options you acrtiavted manually?