Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Digiprog3 ST27 Focus '98-'02 ERROR
17-07-2016, 21:48 PM,
Post: #1
|
|||
|
|||
Digiprog3 ST27 Focus '98-'02 ERROR
I've got a Digiprog3 V04/94M
I tryed many times correction a Focus Visteon dash 98 to 2002 with Motorola MCU. I think this is HC11E9 Mask: E28B Every time I've got "ERROR" meassage. Same than with no connection. I'm using plug27 +one wire soldering to TP3 or TP46. The wires and connectors is correct! Try to: -MCU 1 and 2 pin to bridge -Modified dash connectors like Enigma (dash connector pin 1 and 2 to ground. Digiprog ST27 use only pin 1 to ground) No solution |
|||
17-07-2016, 22:24 PM,
Post: #2
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
Never had any luck with Digi clone on HC11 processors.
You have to remember, the manuals were written for original Digiprog, and the clones are not as good. UPA USB is probably better solution. If someone took the time to help you, the least you can do is take a few seconds and press two buttons!
Thanks + reputation. |
|||
Reputation: +1 - Diagnostix [+1] | |||
18-07-2016, 04:18 AM,
Post: #3
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
|
|||
30-10-2016, 18:11 PM,
(This post was last modified: 30-10-2016, 18:12 PM by Hazzard.)
Post: #4
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
ST 27 cabel its work on digiprog3 chahge pin
I m a pictures ST27 and good work |
|||
28-12-2016, 19:50 PM,
Post: #5
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
You can do with old Tachopro
Послато са D6503 уз помоћ Тапатока |
|||
01-01-2017, 10:50 AM,
Post: #6
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
It works if short two resistors 1k (R17 and R18).
test me and work 100% |
|||
01-01-2017, 11:35 AM,
Post: #7
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
You have tried with special adapter to read digiprog processors?
|
|||
01-01-2017, 21:48 PM,
Post: #8
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
|
|||
01-01-2017, 22:10 PM,
Post: #9
|
|||
|
|||
RE: Digiprog3 ST27 Focus '98-'02 ERROR
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content