[piteerus]

I got S1000XR 2018 with OBD2 (not round) and ENET cable doesn't work. Esys doesn't work. I have K-Dcan cable and can connect with ISTA+ and read data. Kinda works.

I need to change USA miles to kilometres do you have any recomendations how could I do it? Is it possible w NCS-Expert to read params from KOMBI, modify and write them back with K-Dcan cable or do I need ICom?

[TheNine90]

Better use ICOM for that

[piteerus]

Small updated, I got the ICom clone... it works with ISTA+ (v4.41). I can connect, read data, perform tests, clear fault memory. What doesn't work is programming & Vehicle Manipulation tab in ISTA. Can't program, can't change, can't code (all tabs reports ICOM connection is bad).

I have power supply set to 13.7 V. ISTA reads KL15 & KL30 perfect 13.8V.

I problem I might see is I have lates SP-Data (~v70) which doesn't have K001 chassis (the last one was spdata v65 where I can't get it anywhere).

Please help.

[TheNine90]

K001 is psdzdata not sp daten