[cubica]

It was fw v1.39 and older sw 2010, and opel corsaD 2007y...I need to go inside IPC and SDM on SWCAN 33kbps but not possible...other protocols work fine, K line, CAN MSCAN, HSCAN,..
than I have upgraded form v1.39 ti v1.59 and use VAUXCOM....same thing...so, I have concluded it is about interface problem.

Did somebody has same problem...how can I solve this? Till this moment I have tried to change place of all relays, replace position of U5, U6 (MCP2551I), ...unfortunately w/o success.
which one pin or relay is SWCAN?

regards,
cuby

solved..one of marked relays...i will tell u which one later...I have changed position of them..now SWCAN works but can not see EHU...
The car is started, all components ECM-BCM-immo-SDM-IPC are programmed successfully !!

regards,

cuby