Posts: 434 Threads: 43
Threads: 43
Thanks Received: 606 in 211 posts
Thanks Given: 577
Joined: Nov 2013
Reputation:
231
RE: Opcom SWCAN doesn't work (SOLVED)
(31-07-2016, 18:33 PM)cubica Wrote: It was fw v1.39 and older sw 2010, and opel corsaD 2007y...I need to go inside IPC and SDM on SWCAN 33kbps but not possible...other protocols work fine, K line, CAN MSCAN, HSCAN,..
than I have upgraded form v1.39 ti v1.59 and use VAUXCOM....same thing...so, I have concluded it is about interface problem.
Did somebody has same problem...how can I solve this? Till this moment I have tried to change place of all relays, replace position of U5, U6 (MCP2551I), ...unfortunately w/o success.
which one pin or relay is SWCAN?
regards,
cuby
solved..one of marked relays...i will tell u which one later...I have changed position of them..now SWCAN works but can not see EHU...
The car is started, all components ECM-BCM-immo-SDM-IPC are programmed successfully !!
regards,
cuby
The following 1 user says Thank You to cubica for this post:1 user says Thank You to cubica for this post • Red_Mango