[daiyan]

I found the chip but when i read it with digiprog 3 eeprom obtion it just show fff on every line??? what to do?? were should the red cable on clip be on the chip?

---

please someone????

let's see Daiyan. is easier to change the eeprom from one unit to the other. than reading and writing, most of the time to do this you need desoldering eeprom


fussed all by yourself, or you really want to change the Km
[/quote]

first of all i want to get a bsi to run with my car since my original is total damaged. i have removed the chip, should i use digiprog 3 with it to read eeprom? and should i put the clip on the chip as is? would that not break the chip silver pins? and the clip have the red wire on it wich silver pin on the chip does the red wire goes on?

---

irst of all i want to get a bsi to run with my car since my original is total damaged. i have removed the chip, should i use digiprog 3 with it to read eeprom? and should i put the clip on the chip as is? would that not break the chip silver pins? and the clip have the red wire on it wich silver pin on the chip does the red wire goes on?