Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
IBeat 2.1.0 Diagnostic Software for Husqvarna/Mikuni
18-05-2015, 19:19 PM,
(This post was last modified: 18-05-2015, 22:56 PM by volavka.)
Post: #1
|
|||
|
|||
IBeat 2.1.0 Diagnostic Software for Husqvarna/Mikuni
Hi to all motorbikers fans and CarTechnology Members
Here IBeat 2.1.0 Diag. Software for Husqvarna/Mikuni high-performance fuel injection system & their components for motorcycles & speciality vehicles. This should work with KKL cable. "K" Line. tested on the bench was with KeySpan USB to KKL set to COM 1 to install Installation: Run ISO image and install Choose your language Choose your COM port Connect to data link Manual inside CD Note: Husqvarna motorcycles uses an Engine Management System (EMS) and features Mikuni electronic fuel injection. Testing is required for the Keihin EMS systems. Check for the correct controller and use a schematic before any connection. The diagnostic connector for the Husqvarna is behind the headlight or under the fuel tank. The software allows for 3 fuel adjustment points. The adjustment points are low, medium & high RPM. Adaptations include: The throttle position sensor (TPS) recalibration Do this after: Ignition system reset Fault reset Throttle body cleaning Throttle body replacement Adaptation after battery disconnect Languages: English French German Italian Japanese Spanish Best Regards |