[armenh7]

Working on a 2017 G30 530i.
The owner ran flexray initialization with ISTA and from there, it all went bad. All modules on flexray (DME, DSC, EPS, ACSM) show red in ISTA. The engine starts but no steering assist.
I tried to run steuern_flexray_pfad on all 4 ports but they all stay closed even though tool32 says the job is a success. Also, when I press read ECU in ESYS, it only reads 18 (doesn't read any on flexray). I'm not sure if that's expected, however, when I calculate the SVT_soll, it has 25 ecus. I ran steuern_reset_learn_flexray and still nothing.
I read some cases where writing SVT_soll to VCM would fix it so I tried it but still no luck. Any pointers?