[evaldazj]

Hi, anyone solved problem programming CIC in E series with NEXT through most is impossible? I have genuine NEXT with 3.15.00 firmware and old A1 clone icomB. With old A1 clone goes perfect, with NEXT programs first part in 1,5h, and then stops on 0%. In F series takes about 2.5h to flash cic, it is normal?

[MaxBmw]

The original ICOM Next with 3.14.10 or 3.15.0 software works perfectly
Exx cic

[yippy]

You mean, its a clone problem?

[masa52]

I think more related to software issue than hardware if only with cic problem

[evaldazj]

The original ICOM Next with 3.14.10 or 3.15.0 software works perfectly
Exx cic

No it won't, it's original with 3.15.0 allready, but with clone icom B adapter, maybe there is problem?

[MaxBmw]

The original ICOM Next with 3.14.10 or 3.15.0 software works perfectly
Exx cic

No it won't, it's original with 3.15.0 allready, but with clone icom B adapter, maybe there is problem?

Not to be confused - ICOM B clon works perfectly with the original ICOM Next
Exx CIC

[SweetBMW]

BMW Claims the problem was with ICOM FW. All release notes from ISTA P says to be exptected fixed with FW 3.15.00.

[evaldazj]

I was selected REMOTE:MOST_ASYNC_ab625 with easyconnect, maybe there problem is?

[evaldazj]

Any sugestions? With my old A1 clone on same PC goes perfect.

[markmich]

Hello,
ICOM Next works correctly only with ICOM Next B. Original ICOM B and Chinese ICOM B have a problem with CIC, checked on two ICOM NEXT.
Best Regards
MM