Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
NBT Retrofit Issues
27-09-2018, 22:51 PM,
Post: #1
|
|||
|
|||
NBT Retrofit Issues
I have recently Retrofitted a NBT into my Pre Lci F11 car with a Bimmerretrofit adapter, but i have a few issues i can't figure out, anyone have a soultion for this?
These are the issues i have: *Not possible to use the Scroll wheel on the steering wheel to change tracks etc... *The Gps is not working properly (The blue arrow on the screen can suddenly pop out of the road and then back again) *The oil level bar not showing anything. *No sound from the PDC altough camera and sensors are showing up at the screen. |
|||
30-09-2018, 21:11 PM,
Post: #2
|
|||
|
|||
RE: NBT Retrofit Issues
Does anyone have a solution for one or more of the issues?
|
|||
30-09-2018, 22:09 PM,
Post: #3
|
|||
|
|||
RE: NBT Retrofit Issues
are you sure you have the correct GW table coded ?
Email: [email protected] Skype: [email protected]
HU Engineering Tool MGU Engineering Tool - now with field update mode via Feature Installer. Coding 2.0 |
|||
01-10-2018, 20:15 PM,
Post: #4
|
|||
|
|||
RE: NBT Retrofit Issues
|
|||
02-10-2018, 07:22 AM,
(This post was last modified: 02-10-2018, 07:23 AM by bmwcoder75.)
Post: #5
|
|||
|
|||
RE: NBT Retrofit Issues
(01-10-2018, 20:15 PM)Haug530d Wrote:(30-09-2018, 22:09 PM)pshoey Wrote: are you sure you have the correct GW table coded ? Gw tabke 5 is wrong. Change to 1 Anyway you must VO code the unit with proper FA file. You should not have this type of issue |
|||
02-10-2018, 13:33 PM,
(This post was last modified: 02-10-2018, 14:01 PM by Haug530d.)
Post: #6
|
|||
|
|||
RE: NBT Retrofit Issues
How can you be so sure it is Gw table 1? In the Bimmerretrofit instructions it says 5.
I have tried 0,1,2,3,4,5,6,7,8 and 9, no difference at all. The NBT is FA coded for my car. |
|||
02-10-2018, 15:07 PM,
Post: #7
|
|||
|
|||
RE: NBT Retrofit Issues
Somehow the Adapter isn't communicating over the MOST network as if i disconnect the Most Wire from the Bimmerretrofit adapter and the ZGW there is no difference.
But if i disconnect the MOST between the NBT Quadlock and the Car, the clock setting goes away also the service intervals dissapear. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content