[donesko]

x3 f35 , only changed this:
Variante_Antrieb
Allrad (01) -----> Heck (00)

Funktion_LaengsMomentVerteilung_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_HillDecentControl_aktiv
aktiv_kmh (01) -----> nicht_aktiv (00)

and disconnected vtg moudl , works fine

[Adekborys69]

In DSC change parameters:

Variante_Antrieb
Allrad (01) -----> Heck (00)

Funktion_LaengsMomentVerteilung_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_HillDecentControl_aktiv
aktiv_kmh (01) -----> nicht_aktiv (00)

Funktion_LMV_FestBremsSchutz_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_LMV_KupplungsSchlupfAbbau_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_LMV_HarterSchutzEingriff_aktiv
aktiv (01) -----> nicht_aktiv (00)

Funktion_LMV_MomentenabsenkungSegeln_aktiv
aktiv (01) -----> nicht_aktiv (00)

---------------------------------------------------------

In ICM change parameters:

IcmKod_B_S203A
verbaut (01) -----> nich_verbaut (00)

IcmKod_B_HLenInIcm
verbaut (01) -----> nich_verbaut (00)

C_HDC_vorhanden (C HDC present)
ein (01) -----> aus (00)

--------------------------------------------------------

In EGS change parameters:

Allrad (All-wheel drive)
aktiv (01) -----> nicht_aktiv (00)

Now remove both fuses feeded VTG module and clear CAN adaptation and Rear Axle in EGS and car must go sleep. After that clear all errors and you have fully RWD. Have fun.

Thanks just done it in F25 all working fine 
( to disconect VTG pull out fuse 37 but not 66 as have few errors with airbag passanger light and rain sensor , so pulled out PIN 11  RED PLUG in ecu Box ) then no errors at all hope this helps

[Geniom]

Hello, for bmw f07 530dx from 04/2011 all coded in 2014 years is possible remove xdrive? Delete work only from 11/2011 and not for f07, but is the same at f10....
Have you a solution? Thanks to all

[grizzle]

Open your DDE program in Tool32 and use function ecu_config_reset and turn off ignition, close car and wait 20 minutes. After that you can clear that error Have fun with RWD

How can i find my dde .prg? Its F32 With B47 Engine.

[Fatalix]

Open your DDE program in Tool32 and use function ecu_config_reset and turn off ignition, close car and wait 20 minutes. After that you can clear that error Have fun with RWD

How can i find my dde .prg? Its F32 With B47 Engine.

Look at your identification data in INPA under Fxx series.

[kami2k]

is there a 100% tested solution?