Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Icom Next restore
06-08-2016, 11:09 AM,
(This post was last modified: 06-08-2016, 11:15 AM by gyanyx.)
Post: #11
|
|||
|
|||
RE: Icom Next restore
In order to solve your incident, please apply the following steps:
Note: DO NOT UNPLUG the {ICOM Next} from the {OBD II} jack after an update via {ISTA}, a web interface or an emergency software update. The {ICOM Next} starts with flashing green SYSTEM {LED}s. After about 10 seconds it shows red {LED}s for about 2 minutes. After this, the {ICOM Next} reboots due to a firmware update. If the {ICOM Next} {LED}s remain red for more than 10 minutes, or if the {ICOM Next} is unplugged directly after an update, please carry out the following procedure: 1. Please ensure that ALL of the following prerequisites are satisfied: 1.1. You require a {USB} 2.0 or {USB} 3.0 flash drive. ({USB} 1.x flash drives are not supported). 1.2. The {USB} flash drive must be formatted with a {FAT32} file system. 1.3. A minimum of 60 {MByte} free space is required on the {USB} flash drive. 2. Navigate to "{C:\ProgramData\BMW\ISPI\data\TRIC\ICOMNext\ICOM-Image-03-14-08}". ProgramData folder is hidden by default. In that case, you have two options in order to access the file or the folder: - change the settings directly in the Windows Explorer ("Tools => Folder Options => View => Show hidden files, folders or drives") - or enter the whole path into the Windows Explorer's address bar and press enter. 3. Copy "{ICOM_Next-rootfs-010002.tar.gz}" to the root directory of the {USB} flash drive. 4. Copy "{ICOM_Next-app-010008.tar.gz}" to the root directory of the {USB} flash drive. 5. Disconnect the {ICOM Next} from the power supply. 6. Plug the {USB} flash drive into the {ICOM NEXT}. 7. Press and hold the button pressed on the {ICOM Next} and connect the {ICOM NEXT} to the {OBD II} jack of a vehicle. 8. Keep the button pressed. The {ICOM NEXT} starts with all {LED}s glowing red. The {LED}s stay red; some may flicker orange/yellow. Keep the button pressed. 9. Keep the button pressed. After about 4 seconds, all {LED}s turn orange/yellow. All {LED}s now glow in the same colour. 10. Release the button and then press it three times within five seconds. The {LED}s glow or flash red and orange/yellow again. 11. Wait: This procedure may take several minutes. Do not disconnect the {ICOM NEXT} as long as any {LED} glows red. 12. After about 5 minutes the SYSTEM {LED} turns green again. The {ICOM NEXT} has been updated and is ready for use. IMPORTANT: When the software update is complete, the {ICOM NEXT} needs to be connected to the dealer's network in order to be reconfigured. All previous settings are lost during the update. If there is a "{user.settings}" file on the {USB} flash drive, it will be applied after the firmware update. here are recovery files . just unzip the folder and copy those 2 archives on USB root folder. do not unzip them again. If for any reasons you`ll need recovery files for older 05 version please PM. Always use ---> reputation ---> thx---> if my post was helpful... |