[vincentnini2011]

Seems we need an ICOM to get DSC coded :/

[anemos45]

I code it my dsc in my mini r56 s 2008.
k+dcan camble does not read this module in NCS expert . I have k+dcan camble and reads all other modules expect this one.
So, i bought a chinese icom and connect it with NCS EXPERT and ISTA.
Then i backup my settings from my orizinal dsc.
After install a used one dsc from a CLUBMAN wich had the same part number with mine.
I open INPA via icom, and found that he had the vin number from the donor car.
I change the vin number using winkfp via icom .
Then i code it with via NCS expert connect it via icom. When i code it, i open in second window the settings, witch i had backup, and i did exactly the same coding.
I finished all these and when i start the engine appeared a message said "dsc error". I read the error with ISTA and found that the used dsc needs callibration. I went to a mechanic wich had DIS and he calibrate it and ready.
No error , not anything

[jimmy1022]

2011 model, ista says dsc does not need calibration after certain version of software, tried to flash old version of software back with winkfp but I am struggling, is there a specific way to flash backward?

[vanos batam]

K+dcan
Will not work..
You need Good icom device