Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
ICOM A1 & A2 & NEXT Quality (NEW PCB PICTURES!)
11-04-2016, 18:47 PM,
Post: #34
|
|||
|
|||
RE: ICOM A2 Quality (PCB PICTURES!)
(05-04-2016, 12:48 PM)delete Wrote: Hello, Majority of Chinese icoms look same.Just check if the pins of the wifi card holder are properly soldered to the main board.On mine clone A2,the pins were not even soldered to the board.When i tried to add wifi card,wifi card was not responding.So then i discovered that problem and i had to manually soldered each single pin. Regarding the power pin you are talking about,actually its not a power plug,its there to connect ICOM with IMIB(Integrated Measurement Interface Box).IMIB is another bmw diagnostic tool which contains oscilloscope,multimeter etc.Mine clone has a proper 5 pin imib connector as shown in the picture. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
3 Guest(s)
3 Guest(s)
Return to TopReturn to Content