Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
ICOM A1 & A2 & NEXT Quality (NEW PCB PICTURES!)
09-08-2018, 12:14 PM,
(This post was last modified: 09-08-2018, 12:17 PM by willisodhiambo.)
Post: #58
|
|||
|
|||
RE: ICOM A1 & A2 & NEXT Quality (NEW PCB PICTURES!)
Mine did this and after a while I lost ethernet. Soon it started loosing connection and eventually just went dead. I could still see IP address but could not connect. Red flashing system LED
Attempted to repair it and things just went south. I think it got damaged by heat since I was doing an E65 and used the ICOM in the engine area then in the next connection I noticed the red LED. After two more clones that did not work I have now ordered a genuine next. The amount of money I wasted chasing after clones should have been well spent on an original. Never again. Strangely the old clone was similar to yours, worked 100%. I don't know why those cloners stopped doing proper equipment. One of the clones I have shows 2v in KL15, the other used so show ethernet in configuration page though would indicate no ECUs connected, I could never connect ISTAP so I guess it was a faulty ethernet. I would still be happy to try repair them just for the heck of it, If I could get a circuit board diagram. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
5 Guest(s)
5 Guest(s)
Return to TopReturn to Content