[neo123]

Hi there new to the forum.

I was wondering if anyone can help. I recently purchased digiprog 3 v 4.85 from china.

I am trying to adjust the mileage for a 2007 mk3 Mondeo. It states I need the hc12 cable. THe cable I have has different colours to what the cables they show on the instructions.

My HC12 cable shows red, black, light orange and brown.

Whereas the manual shows white, brown, green and yellow. How can I match the wires.

In addition my speedo 32 pins are different to the ones in the instructions. Does anyone know where I can solder the positive and negative and which wires goes on the reset. thanks in advance

pics below any help appreciated

[img][/img]

[teerak2uk]

Look at the 25 pin on ST51 plug

Brown. 13
Green 17
Yellow. 18
White 25

Ignore your colours just go by the pin numbers as the chinks prob ran out if the correct coloured cable

[neo123]

have they given me the wrong cable, this is how its connected

[sashxxx]

If it is clone will not work with hc12

[neo123]

What do you mean clone?

I purchase digiprog 3 v.4.85 from china can this not do Mondeos?

[sashxxx]

China clone don't have support hc12

[neo123]

On the digiprog 3 there is an option for hc12 and the hcs12.

They gave manual too but the colours are different. When I select Mondeo and hc12 on digiprog it says u need cable 51, I have the cable 51. Just don't know how to connect up cause colours are different.

[Kris81]

Digiprog will do it by obd connector.

[neo123]

Digiprog will do it by obd connector.

but this is the mk3 Mondeo not the mk4 Mondeo.

Mk3 Mondeo u need to take the speedos out?

[Kris81]

My mistake, u can read this by bdm points on the back of the clock, with standard programmer ( upa or xprogm.