Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
VAG VW EDC17/MED17 IMMO Transfer/Cloning/IMMO OFF - Pin Mac and CS Extraction
17-07-2018, 07:29 AM,
Post: #81
|
|||
|
|||
RE: VAG VW EDC17/MED17 IMMO Transfer/Cloning/IMMO OFF - Pin Mac and CS Extraction
(17-07-2018, 07:00 AM)Dee89 Wrote:(16-07-2018, 19:58 PM)dijo Wrote:(16-07-2018, 19:47 PM)Dee89 Wrote:(16-07-2018, 19:02 PM)dijo Wrote:(16-07-2018, 16:46 PM)Dee89 Wrote: Could someone help me clone/transfer data from old to new ecu? ohhhh, you are right, sorry! I replace the file, please check it... |
|||
21-07-2018, 10:33 AM,
(This post was last modified: 21-07-2018, 10:35 AM by cbyriel.)
Post: #82
|
|||
|
|||
RE: VAG VW EDC17/MED17 IMMO Transfer/Cloning/IMMO OFF - Pin Mac and CS Extraction
(15-07-2018, 20:48 PM)dijo Wrote:(15-07-2018, 20:01 PM)cbyriel Wrote:(15-07-2018, 19:55 PM)dijo Wrote:(15-07-2018, 19:22 PM)cbyriel Wrote:(15-07-2018, 19:20 PM)dijo Wrote: ups, sorry, i mixed your date with others from another car... So unfortanetly your solution did not work new ecu goes into immobilizer >I need some help regarding cloning of a EDC17c64. I just recently learned >about not being able to transfer software directly from one EDC17 to >another, because of OTP. >My Old ecu is EDC17c64 - 04L906021EQ 7540. I did make a complete >backup with K-Tag clone of EPROM and Internal Flash which is included in >the "OLD ECU" dir in the attached file. >New ecu is EDC17c64 - 04L906021EQ 6284. I also made a complete >backup of that, included in "NEW ECU" dir, of EPROM and Internal Flash. >VIN is VSSZZZ5FZFR058329 if needed. >I have a couple of small question though: >Firsly ofcause if transfer is possible for these 2? >Secondly - before i needed to replace the original ECU i had a tune made, >based on the original files from the old ecu - will i be able to use this tune >after transfer (if only the EPROM is modded?) - if not - would it be possible >to use the tune as the base for the modifications? (if not, too bad - i will >have to get it re-made then). Just in case i have included the tune in the >"OLD ECU" dir and the file is called .tune >And if ECU's wont match, would it be possible to make a immo off of the >old original that i can then use on the new ecu (no warning >lights/errorcodes)? >Thanks alot in advance! So i still am in need for a solution for the above, i did get a file from Dijo - however this file did not work |