[Kenny]

Hi

Equipment part no. 96 539 589 80
Equipment additional reference 96 642 575 80
Software reference 96 665 040 80

Can someone please assist with FAP/DPF off.
I tried with free software on forum but i am still having a problem.

With the file done with dpf remover i have no faults in engine ecu.
When starting it says additive low.
With the file loaded i cant seem to go into configurations at all.
When i do additive filling on diagbox it says done but same error.

Do i need to unplug anything?
Can someone check file and see if its ok?

Thanks

[benii75]

Your file, first reset your dpf soot with diagnostic tool then flash the file and check is problem is gone

[Kenny]

Thanks for the file.
I actually came right with my file with a bit of ingenuity.

I put original file back.
Done reset fluid etc.
Read a new file and ran it through DPF remover 2017.
Wrote new file to ecu.
No faults in engine ecu but when i started the car warning for additive level came on dash.
I then went to bsi config.
Ecu's present i changed additive ecu to absent.
Then in vehicle config engine i changed additive pump to absent .

So far so good.
No faults on dpf or additive systems.

Thanks again for file and assistance.

[benii75]

That's good my friend have i nice day