Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Carprog MCU erase
08-06-2014, 14:04 PM,
Post: #1
|
|||
|
|||
Carprog MCU erase
Hello m8's. I have strange problem - can not erase mcu(at91sam7s256) to program with new software. I try everithing put 55pin from mcu to erasing point and wait 30 minutes to erase and after i connect carprog to computer software see the box. so mcu is not erased. Any suggestion will be very helpful.
I want to reprogram it because i have error on the picture. |
|||
08-06-2014, 18:03 PM,
Post: #2
|
|||
|
|||
RE: Carprog MCU erase
Did u lift pin 55?
if my post helps please give Reputation and Thanks
|
|||
08-06-2014, 22:45 PM,
Post: #3
|
|||
|
|||
RE: Carprog MCU erase
(08-06-2014, 18:03 PM)tango Wrote: Did u lift pin 55? Yes i lift the pin, i reprogram few carprogs of my friends, but i do know what happend with my carprog. I read datasheet about this mcu and erase pin have 3.3v when i measure the voltage on the pcb of carprog the voltage for erase is 3.25-3.53. So everithing must be fine but Mcu can not erase the flash. in atachment is datasheet. May be is blocked for erasing, any ideas !?!? |