[proaudio]

Need howto for digiprog. 2005 ford 500
has mc9s12. Has 6 pin quick jump on it. Use st48 an it init and reads just wrong km

what am I missing

[Clusters]

Need howto for digiprog. 2005 ford 500
has mc9s12. Has 6 pin quick jump on it. Use st48 an it init and reads just wrong km

what am I missing

May read the same as a Freestyle, not in digi manuals but listed in enigma.

[proaudio]

Thanks but no that doesn't work it has the six pin connector and I can connect st48 to it and under pretty much any car listed with hc9s12 will read just reads wrong mileage and it will even write and change whatever wrong data its reading I just don't know

[Clusters]

Thanks but no that doesn't work it has the six pin connector and I can connect st48 to it and under pretty much any car listed with hc9s12 will read just reads wrong mileage and it will even write and change whatever wrong data its reading I just don't know

So you're trying to change it using digi under car makes. Do it manually.

Under eeprom select SET TYPE: EEPROM/MCU/9S12

Save a copy of the .bin so you have a backup, edit it manually, write it back.

Problem may be figuring out the algorithm, it may be the same as Freestyle in Tachosoft. If not, you could post the .bin, original, and desired mileage here and someone may be able to modify it for you.

---

Thanks but no that doesn't work it has the six pin connector and I can connect st48 to it and under pretty much any car listed with hc9s12 will read just reads wrong mileage and it will even write and change whatever wrong data its reading I just don't know

A few more thoughts. That statement worries me, if you have overwritten the original file with wrong data you may be stuck with a corrupted file. Since you played with it, have you tested the cluster to see if it works properly and the car starts?

If digi doesn't read the correct mileage, you should never write anything.

Your located in the US, right? Tried converting the readings to KM?

[proaudio]

Cars fine I saved original so I put it back on
I can read. But THERE no calcs for ford 500. There's no info on where mileage blocks are to.manually edit it or I would

[Clusters]

Cars fine I saved original so I put it back on
I can read. But THERE no calcs for ford 500. There's no info on where mileage blocks are to.manually edit it or I would

Upload the file here, with original mileage.

[proaudio]

I can't. Digi and eetool won't save mcu files to computer only eeproms

---

An its not the conversion I've done thousand ford's with it I only have to convert audi and vw. An I do that with x431 in computer then digi then back to us

---

It's not f500. It's a 500 car

[Clusters]

Without seeing the file, I can't help. You could do it the hard way, type info into hex editor to make a .bin.

I know it's a car, that's why I mention Freestyle.

Good luck