Ford focus 2010 Calibration and manual - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: Ford - Mazda (https://cartechnology.co.uk/forumdisplay.php?fid=69) +---- Thread: Ford focus 2010 Calibration and manual (/showthread.php?tid=17323) |
||||||||||
Ford focus 2010 Calibration and manual - mreza73 - 31-07-2016 Hi again i need calibration codes for ford focus VIN: WF0FD95L0ALK19141 i also need repair manual and wiring for this car because it's german ford (MFG by ford werke gmbh) it's different with USA focus work shop RE: Ford focus 2010 Calibration and manual - mreza73 - 06-08-2016 If someone sends me just calibration it will be very good tnx RE: Ford focus 2010 Calibration and manual - sev611 - 06-08-2016 I think you should give the gem module closer look because the only module ids is seeing is the ipc al module is connected by the gem indeed see the connetors on the uppef levt side of gem and on the down side the 2connectors get loose and then there are no comunication to the othef module check dlc 3-11 and 6-14 there should be 60ohm +- 2 ohm RE: Ford focus 2010 Calibration and manual - mreza73 - 09-08-2016 (06-08-2016, 22:33 PM)sev611 Wrote: I think you should give the gem module closer look because the only module ids is seeing is the ipc al module is connected by the gem indeed see the connetors on the uppef levt side of gem and on the down side the 2connectors get loose and then there are no comunication to the othef module check dlc 3-11 and 6-14 there should be 60ohm +- 2 ohm thanks i will check can network ohms but when i was connect MS can from radio to GEM module (direct) it's passed the network test but not any other modules pass the test and i need wiring diagram for testing can on PCM socket side my main problem is finding CAN wires on pcm this is my GEM module and all ceonnector are connected and seems to be ok (two sockets is on back side) RE: Ford focus 2010 Calibration and manual - sev611 - 13-08-2016 I have tried to print some wireing diagrams as pdf but dont know how to attach them to this post ps i think i found out rgds sev
|