+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: CHIPTUNING (https://cartechnology.co.uk/forumdisplay.php?fid=12)
+--- Thread: EDC15p+ VW Passat pinout problem (/showthread.php?tid=17704)
Pages:
1
2
EDC15p+ VW Passat pinout problem - esm1r - 20-08-2016
Hello friends
I have problem with edc15p+ pinout, +12 on pin 37 & 2
GND - pin 3
K-LINE - (green wire - galletto v54 clone) - pin 16
And eobd2 wont detect it or read, even write. Can anyoone help me?
RE: EDC15p+ VW Passat pinout problem - teerak2uk - 20-08-2016
Try boot connection
Check wiring in plug
RE: EDC15p+ VW Passat pinout problem - esm1r - 20-08-2016
(20-08-2016, 15:17 PM)teerak2uk Wrote: Try boot connection
is there any instructions avaible?
(20-08-2016, 15:17 PM)teerak2uk Wrote: Try boot connection
Check wiring in plug
i checked , green wire is on good place in connection to galleto
i dont know what is problem
EDC15p+ VW Passat pinout problem - teerak2uk - 20-08-2016
![[Image: 591fda091f6b11a5e2743ff2a58df992.jpg]](http://uploads.tapatalk-cdn.com/20160820/591fda091f6b11a5e2743ff2a58df992.jpg)
RE: EDC15p+ VW Passat pinout problem - esm1r - 20-08-2016
I tried that, and in description box on galletto software is error: BOOT MODE INACTIVE
RE: EDC15p+ VW Passat pinout problem - teerak2uk - 20-08-2016
Remove chip and read/write option then
RE: EDC15p+ VW Passat pinout problem - esm1r - 20-08-2016
Only that option?
RE: EDC15p+ VW Passat pinout problem - abdel59 - 20-08-2016
Hi
you use mpps or fgetch?
see this pictures
i hope i can help you
RE: EDC15p+ VW Passat pinout problem - esm1r - 21-08-2016
(20-08-2016, 19:35 PM)abdel59 Wrote: Hi
you use mpps or fgetch?
see this pictures
i hope i can help you
i use galletto v54 clone, same wiring conection, i try that, no success...
RE: EDC15p+ VW Passat pinout problem - Bimmeristi - 21-08-2016
Connect Galletto socket to ecu
Connect pin 24 29f400 to GND (use also ~1kohm resistor if available).
Power ON ECU.
After 3-5 sec disconnect pin 24 from GND.
Start Galletto program.