Citroen C5 mk2 Steering Angle Fault (ESP Warning) - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: PSA Group (Citroen - Peugeot) (https://cartechnology.co.uk/forumdisplay.php?fid=56) +---- Thread: Citroen C5 mk2 Steering Angle Fault (ESP Warning) (/showthread.php?tid=48167) |
Citroen C5 mk2 Steering Angle Fault (ESP Warning) - Tsunami41 - 17-03-2019 Hi, I have Citroen C5 mk2 1.6HDi which has steering wheel angle sensor problem. I have checked it with Lexia. About problem, it occured after when I have dismantled dashboard because of faulty climate clacks. Now I don't know sensor problem caused by faulty sensor, cable or connection. When I looked to lexia for troubleshooting, i have found some instructions. But I couldn't find the connectors to check insulation and continuity. Can anybody show me the place of connectors? By the way I don't know can I measure the cables and connectors with my basic multimeter. Do i need any specialized tool for Citroen? If yes, can anybody send me the link, photo etc? I am adding instruction photos captured on lexia. Thanks in advance. RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - AROUNDLOCKS - 18-03-2019 HI HERE IS SCHEMATIC OF SENSOR HOPE THIS HELPS IF MORE HELP NEEDED JUST GET BACK HERE DONT FORGET THANKS AND REP REGARDS AROUNDLOCKS RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - Tsunami41 - 19-03-2019 (18-03-2019, 01:45 AM)AROUNDLOCKS Wrote: HI Thanks for your help. I will check them asap then i will write the situation. RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - Tsunami41 - 22-03-2019 (18-03-2019, 01:45 AM)AROUNDLOCKS Wrote: HI I have checked the cables, new are not good. I read 120ohs between can-h and can-l. I don't know what I have to do. By the way I made measurements while 47V BE connector of the ESP ECU unconnected. I am waiting for your help. I have follow lexia instrucions too and the values are below. 47V BE 15 to 47V BE 16 14,2kohm 47V BE 11 to 47V BE 16 14,2kohm 47V BE 11 to 6V BE 2 1,4ohm 47V BE 15 to 6V BE 1 1,1ohm 47V BE 47 to 6V BE 3 0,1ohm 47V BE 11 to 47V BE 15 121ohm 47V BE 11 to 47V BE 47 14,2kohm 47V BE 15 to 47V BE 47 14,2kohm 6V BE 3 to 6V BE 4 400ohm 47V BE 11 to 47V BE 16 2,5V RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - AROUNDLOCKS - 23-03-2019 HI BUD RIGHT EXACTLY WHAT FAULT CODES ARE COMING UP ON THE CAR IS IT STEERING ANGLE FAULT OR ESP FAULT IM SENDING YOU ESP SCHEMATIC OVER ANYWAY JUST IN CASE JUST MAKE SURE BATTERY DISCONNECTED WHEN TESTING WIRING IF YOU ARE STUCK JUST POST FAULT CODES UP AND I WILL TRY AND HELP YOU MORE AS I WILL HAVE A BETTER UNDERSTANDING OF WHATS GOING ON INSIDE OF THE CAR REGARDS AROUNDLOCKS RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - rightpcb - 23-03-2019 I would not trust AD wiring diagrams on a complex system like Citroen has, sometimes they are wrong and you spend many many more hours looking for problem that is easy fix with correct diagrams RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - Tsunami41 - 23-03-2019 (23-03-2019, 00:00 AM)AROUNDLOCKS Wrote: HI BUD Hi, I have two faults in Abs/Esp menu both of related with steering wheel angle sensor. First is steering wheel angle sensor Internal signal fault, second is steering wheel angle sensor not calibrated. When I try to calibrate, I get an error message "operation not started" And at the paremeters menu steering wheel angle sensor is seen as "not operational", "not calibrated", "adjusted" value is "336541.4" and not change. May be I have a faulty sensor. But before I change it I want to sure everything is ok on car. Steering wheel angle sensor not sold separatly. It is inside the under steering wheel column and it is expensive part. I have working Sedre on my computer too. I have looked the cable diagrams on Sedre but I couldn't understand well, because there is no legant for labeling. For ex, there is a part labeled as cv00 but there is no any information what is cv00 or where is it. And there is no any value to check the measurements. RE: Citroen C5 mk2 Steering Angle Fault (ESP Warning) - Tsunami41 - 24-03-2019 (18-03-2019, 01:45 AM)AROUNDLOCKS Wrote: HI Hi, today I have measure the resistance of can H and can L while ABS/ESP ECU's plug is plugged. And value is 60ohms. I think it seems ok. But SAS seen as still "not operational". I am stuck. Please tell me what I have to do. Regards. |