BMW F31 acc retrofit help - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: BMW F31 acc retrofit help (/showthread.php?tid=59093) |
BMW F31 acc retrofit help - Pedrom92 - 15-01-2022 hello, I retrofitted the ACC on a BMW F31, the system works and there were some errors, I took the BMW to calibrate it, thinking that was the case, but it remains the same. it works for a while and then the error. anyone had a similar problem? I read these faults with bimmerlink. 1C Integrated chassis management 3 errors 4827BF: LDM function HighLevel operational readiness ACC sensors 48002C: LDM function - high-level operational readiness brake control unit D01B2A: Signal error (actual position EPS, ID: AVL_PO_EPS) - Invalid 29 Dynamic stability control MK60 E5 3 errors 4809AB: Global power supply - external undervoltage D35A53: Signal error (actual steering angle front axle, ID: AVL_STEA_FTAX) qualifier D35A62: Signal error (lateral acceleration center of gravity, ID: ACLNY_MASSCNTR) - qualifier 5D Camera-based driver assist system 1 error E06C43: Signal Status_Availability_Kette_Bremsung received invalid or brake chain not available RE: BMW F31 acc retrofit help - Pedrom92 - 21-01-2022 Hello, faults with ista in attachment. it says ACC misadjusted, but the same was calibrated by BMW. and 2 faults appear in the ICM. Any help? Thanks. RE: BMW F31 acc retrofit help - moreply - 21-01-2022 Did properly Code everything? With SA Codes did you use? Does ACC Sensor show up Correctly RE: BMW F31 acc retrofit help - Pedrom92 - 21-01-2022 Yes, i code 5AS already fitt and add 5DF. sometimes it is 1 or 2 days without fault and then the fault appears and does not call for a while. I flash DSC, ICM, FRR, KAFAS, FEM to same ilevel. I do not know what else to do. RE: BMW F31 acc retrofit help - wellwell - 21-01-2022 Did you replace your grill? RE: BMW F31 acc retrofit help - Pedrom92 - 22-01-2022 Yes. Normal bumper. Need put cover. RE: BMW F31 acc retrofit help - moreply - 22-01-2022 I would check the wiring. Had it on an G30 ones. Sensor went on and off. After 4 Hours searching i found a plug that was bad. RE: BMW F31 acc retrofit help - Pedrom92 - 22-01-2022 I will check. but if it was something in the wires you should receive an error message in the ista type disconnected no? RE: BMW F31 acc retrofit help - larshutten - 22-01-2022 Did you correctly mount the acc radar bracket? Also if I remember correctly the lower bumper support is different with and without ACC where you put the bracket on. Has that been changed or not needed for your car? RE: BMW F31 acc retrofit help - Pedrom92 - 22-01-2022 yes it had to be changed too. |