BDM readout of KVM (RFA) module MC9S12XD - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: Ford - Mazda (https://cartechnology.co.uk/forumdisplay.php?fid=69) +---- Thread: BDM readout of KVM (RFA) module MC9S12XD (/showthread.php?tid=63944) |
BDM readout of KVM (RFA) module MC9S12XD - go4it - 29-04-2022 I try to readout the firmware of an 7S7T-19G481-DA keyless-vehicle-module. The unit uses an MC9S12XD microcontroller and i managed to find the BDM pads on the PCB. But connection is interrupted by a (external?) reset-pulse after about 400ms of BDM-reset. Does anybody know if there is an extra reset-chip on the board, needs to be disabled? I access the chip without powering the whole unit, the MCU get's power from BDM interface. RE: BDM readout of KVM (RFA) module MC9S12XD - dimitar - 01-11-2022 I think this one is locked...try lifting reset pin |