[hcip]

Hello
I have Benz W210 1998 year that has a damage EZS, the key not turn and the EZS produce excessive heat on MCU 0d69J

I have here a good EZS from another car also from W210 with keys

my Question is:
Can I put the good EZS from another car and fit it on defective car?
ECU 4E28B has to be virginize and code it on Star?

if possible anybody ca tell me step by step how to code it from star?
I am not familiar using star diagnosis so I ask for procedure

Thanks

[bawareca]

You have to erase the ESL too.
Initial startup is with SD is very easy, just 2 simple steps. The SD will guide you.

[volavka]

Exactly what he said Mr.bawareca
1st must reset esl By writing in both mcu hc905 and fill it FF FF ... except last line, then sync ezs-ecu .. Go To CDI >> Control Module adaptations >> Identification >> so on
Good Luck

[hcip]

Exactly what he said Mr.bawareca
1st must reset esl By writing in both mcu hc905 and fill it FF FF ... except last line, then sync ezs-ecu .. Go To CDI >> Control Module adaptations >> Identification >> so on
Good Luck

Thanks...
Where is the ESL Located?
I search under steering Column.. nothing foud any module there except a Motor

[bolonc]

Motor inside .