[claw]

Hi guys

Car with dead TCB (water damaged). Customer does not want to pay new one from dealer.
To remove TCB, need to remove 6AC and 6AE and code kombi, Entrynav etc.
Also, since micro is connected to TCB, need to rewire to entrynav.
Question: Can i "loop" microphone wires on the connector that was connected to TCB?
Also, is anything more needed to be done?

Thanks

[torchia]

whats is the point to 'loop' wires at the boot and run them back all the way to the HU? or easier to get 2m of cable and run new wire from mic to HU?

[claw]

I may not made my self clear... "loop" is using 3 small wires to join mic pins (in and out) of TCB connector, avoiding run 2m of cable.
If i understand right, schematic is like this: