Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Flash file for W204 Valeo steering column switch.
04-06-2018, 19:54 PM,
Post: #11
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
Im having same error...
But everything else is working nice... just on angle error... Someone already tried to clean it sucessfuly? |
|||
05-06-2018, 02:19 AM,
Post: #12
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
how is the angle error ?
For me, I first install the steering column without steering wheel, the use diagnose tool to read the angle sensor in live and make sure it is near 0° then install steering wheel back to the marked angle. After everything installed and tightened, use diagnose tool to clear all error codes included airbag errors. Test drive and turn steering all the way to left and right and hold for 5sec. couple times respectively. Scan for error codes again, no more errors, good to go. |
|||
05-06-2018, 02:23 AM,
Post: #13
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
Ive got error:
"C220500 There is an internal fault in the steering angle sensor" Everything is from factory... Never touched. |
|||
05-06-2018, 02:30 AM,
Post: #14
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
try clear the error by diagnose tool,
power down - remove key for 2min insert key and turn to position 1, use diagnose tool read the angle..... |
|||
05-06-2018, 02:49 AM,
Post: #15
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
|
|||
05-06-2018, 03:26 AM,
(This post was last modified: 05-06-2018, 03:39 AM by BabeH.)
Post: #16
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
then probably either the angle sensor is damaged,
or it is already turned too many fault angle.... what happen if just reading the angle sensor without steering wheel ? can you read the angle ? or just got error ? |
|||
18-06-2018, 23:34 PM,
Post: #17
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
(05-06-2018, 03:26 AM)BabeH Wrote: then probably either the angle sensor is damaged, Just got the error... As soon i touch the steering. Can be something related to the FW/SW? |
|||
19-06-2018, 07:56 AM,
Post: #18
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
what is the error code ?
do you get any angle reading ? |
|||
13-07-2019, 12:22 PM,
Post: #19
|
|||
|
|||
RE: Flash file for W204 Valeo steering column switch.
I have been searching around but nobody know.
just found a post in China but the info are useless. Assume that your hardware and software should still fine. Take out part 1.2.3. shown in the photo. In [3] there is a white gearwheel, make sure the hole is pointing to the middle teeth on the copper disc. Install back everything, use diagnose tool to read data steam, check if the angle reading is correct. Then clear all fault codes. |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content