Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Does anybody know how to configure ICOM for 100kbit K-CAN mode?
24-10-2019, 11:12 AM,
(This post was last modified: 24-10-2019, 11:13 AM by volaltd.)
Post: #1
|
|||
|
|||
Does anybody know how to configure ICOM for 100kbit K-CAN mode?
Does anybody know how to configure ICOM for 100kbit K-CAN mode and direct communication with ECUs?
|
|||
26-10-2019, 11:07 AM,
Post: #2
|
|||
|
|||
RE: Does anybody know how to configure ICOM for 100kbit K-CAN mode?
Solved with USB D-CAN
|
|||
28-10-2019, 06:20 AM,
Post: #3
|
|||
|
|||
RE: Does anybody know how to configure ICOM for 100kbit K-CAN mode?
btw, in ediabas.ini you need to configure as REMOTE and setup ip which itoolradar shows you
|
|||
30-10-2019, 07:27 AM,
Post: #4
|
|||
|
|||
RE: Does anybody know how to configure ICOM for 100kbit K-CAN mode?
|
|||
30-10-2019, 15:46 PM,
(This post was last modified: 30-10-2019, 15:47 PM by Bimmer540.)
Post: #5
|
|||
|
|||
RE: Does anybody know how to configure ICOM for 100kbit K-CAN mode?
So icom is faster reading modules then obd d-can cable?
|
|||
30-10-2019, 16:22 PM,
Post: #6
|
|||
|
|||
RE: Does anybody know how to configure ICOM for 100kbit K-CAN mode?
ICOM gets comm speed as protocol parameters. There is no need to manually switch it. Of course your software needs to properly send protocol parameters.
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content