[tigri007]

Dear friends, 

I have a problem trying to program new headlight module. Flash is always interrupted with this error:

<[] prepareTALExecution finished [PROGRESS]>

<[] prepareVehicleForFlash started [PROGRESS]>
<MCDDiagService<id=20600, job=com.bmw.psdz.jobs.common.MCD3_PrepareVehicleForFlash, service=CC, description=error: negative response : conditionsNotCorrect, link=#RtGen_MultipleEcuJob_LogicalLink> [DIAGSERVICE]>
<MCDDiagService<id=76600, job=com.bmw.psdz.jobs.common.MCD3_PrepareVehicleForFlash, service=RC_SEM, description=error: negative response : conditionsNotCorrect, link=#RtGen_MultipleEcuJob_LogicalLink> [DIAGSERVICE]>
<[FLM2 - 44] Failed ProgrammingPrecondition ECUId:FLM2_0x44 error ID:192 - supplier reserved [THROWABLE]>
<[] prepareVehicleForFlash finished [PROGRESS]>
<[] finalizeVehicleFlash started [PROGRESS]>
<[] finalizeVehicleFlash finished [PROGRESS]>
<[] prepareVehicleForCoding started [PROGRESS]>
<[] prepareVehicleForCoding finished [PROGRESS]>


Thank you in advance

[elthox]

What faults are in car? Does headlight work?

[tigri007]

There are no errors. FLER is green. Can be coded, but cannot be flashed. Low beam high beam work but halo rings dont work. And no error.

[Node]

Have you activated diagnostic mode in a car? (3x start-stop button within couple s)

[tigri007]

yes tried both modes, with diagnosis mode and car running

[TheNine90]

Which Esys verson is this?

[tigri007]

i tried esys last version 22.10 with 4.39.20 data and esys 3.36 with 4.36.10 data. Same error.

[TheNine90]

Try deactivating parallel programming and uncheck programming counter.
Why are you programming the module? If you coding works then teach-in the headlight using ISTA in service function.

[tigri007]

I never used teach procedure for FLM2. Never was needed. Coding and matrix code input has been enough. I try to flash because there is no coding error or any other error.

[Abou Jambo]

yes tried both modes, with diagnosis mode and car running

Which ISTEP you are using for TAL calculation?