Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Ford focus 2010 Calibration and manual
31-07-2016, 10:39 AM,
Post: #1
|
|||
|
|||
Ford focus 2010 Calibration and manual
Hi again
i need calibration codes for ford focus VIN: WF0FD95L0ALK19141 i also need repair manual and wiring for this car because it's german ford (MFG by ford werke gmbh) it's different with USA focus work shop |
|||
06-08-2016, 09:51 AM,
Post: #2
|
|||
|
|||
RE: Ford focus 2010 Calibration and manual
If someone sends me just calibration it will be very good
tnx |
|||
06-08-2016, 22:33 PM,
Post: #3
|
|||
|
|||
RE: Ford focus 2010 Calibration and manual
I think you should give the gem module closer look because the only module ids is seeing is the ipc al module is connected by the gem indeed see the connetors on the uppef levt side of gem and on the down side the 2connectors get loose and then there are no comunication to the othef module check dlc 3-11 and 6-14 there should be 60ohm +- 2 ohm
|
|||
09-08-2016, 11:24 AM,
Post: #4
|
|||
|
|||
RE: Ford focus 2010 Calibration and manual
(06-08-2016, 22:33 PM)sev611 Wrote: I think you should give the gem module closer look because the only module ids is seeing is the ipc al module is connected by the gem indeed see the connetors on the uppef levt side of gem and on the down side the 2connectors get loose and then there are no comunication to the othef module check dlc 3-11 and 6-14 there should be 60ohm +- 2 ohm thanks i will check can network ohms but when i was connect MS can from radio to GEM module (direct) it's passed the network test but not any other modules pass the test and i need wiring diagram for testing can on PCM socket side my main problem is finding CAN wires on pcm this is my GEM module and all ceonnector are connected and seems to be ok (two sockets is on back side) |
|||
13-08-2016, 09:40 AM,
Post: #5
|
|||
|
|||
RE: Ford focus 2010 Calibration and manual
|