Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Column lock Chrysler C300 Skreem Wcm
17-03-2019, 18:10 PM,
Post: #1
|
|||
|
|||
Column lock Chrysler C300 Skreem Wcm
Hi friends.
I have a start up concern about a 2009 Chrysler 300C 3.0 CRDI. I changed the glow box module because it came out as a fault code. Then it started 2 minutes then cut off and since impossible to restart. The fault code now is B2224 Vehicle Security Control Module (Skreem / Wcm) and the steering column does not lock. A solution friends? I am equipped with a programmer so if it is necessary to correct the electronics by reinjecting a file must tell me. thanks in advance |
|||
17-03-2019, 19:14 PM,
Post: #2
|
|||
|
|||
RE: Column lock Chrysler C300 Skreem Wcm
hi
ive had a quick look at your fault its saying wcm internal fault did you disconnect battery from car when changing glow plug module is immobilizer light staying on permanent if you have a spare key try it to rule out a key fault also there are 3 fuses to the immobilizer system on this car /please check all fuses are all ok in your fuse board in the boot of your car. check all above and reply back here regards aroundlocks |
|||
17-03-2019, 21:20 PM,
Post: #3
|
|||
|
|||
RE: Column lock Chrysler C300 Skreem Wcm
Hi,
no I did not disconnect the battery when replacing the preheating module. I only cleared the fault codes with the pc. I will try to unplug the battery for 10 minutes to be sure of everything. in any case the fuses in the trunk and in the engine are ok |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content