[Raimo5]

I once had same issue with ISTA. Car showed up in connection manager, but when doing full identification, it failed. I used EDIABAS Konfigurator 2.0 to set ENET (second, lower one in the list) configuration and after that, all worked well.

[mcrussell]

I once had same issue with ISTA. Car showed up in connection manager, but when doing full identification, it failed. I used EDIABAS Konfigurator 2.0 to set ENET (second, lower one in the list) configuration and after that, all worked well.

Thanks I will give that a try, its strange through as its always worked fine

---

I once had same issue with ISTA. Car showed up in connection manager, but when doing full identification, it failed. I used EDIABAS Konfigurator 2.0 to set ENET (second, lower one in the list) configuration and after that, all worked well.

Thanks I will give that a try, its strange through as its always worked fine

I noticed Konfigurator offers 2 different port options:
Diagnostic Port 50160
Control Port 50161

Diagnostic Port 6801
Control Port 6811

Using easyConnect it only uses:
Diagnostic Port 50160
Control Port 50161

So if you use the 6801 port would it still be visable in ISTA Connection Manager or would you only be able to use the EDIABAS.INI option in the ISTA Interface page?

[Siki78]

Port 50160/50161 is for ICOM
Port 6801/6811 is for ENET