Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Siemens SID801A, read, write ECU
01-11-2017, 10:16 AM,
(This post was last modified: 01-11-2017, 17:17 PM by grmsek.damjan.)
Post: #5
|
|||
|
|||
RE: Siemens SID801A, read, write ECU
@uikcar, you gave me fhoto for 803A it have bdm pads, my ecu is 801A without bdm pads Its not the same!!!
Today opened ecu and the hw is the same as on SID802,804,805,806 Galletto user manuals..so I used it with boot mode and pin28 on mass.. (when the warning message appear put ignition off, put boot pin on mass( I put it on black gnd wire),turn ignt. on-switch, pud down boot pin from mass)..OK..finally started reading Can anybody check if it is good reading? 512kb (I am a little woried about china galletto) when writing back Is file ori? Thankyou |