[shlema]

Hi, Smart ppl.
I am pulling my last hair out , can’t get KOMBI get back on line.
I have 2016 X1 F48 prod date 15/09, sw ship 1507504.
I retrofited rear PDC and backup camera, camera new retrofit and PDC module used.
Installed and fitted 4 rear sensors, PDC module and ICAM.
Now, because PDC was used and came from Europe, I need to flash it and coded to my car.
PDC prerequisites was BDC_GW. Flashed PDC with BDC_GW and coded as well as HU and BDC. I have all options come up on CID and pdc start working the ways it’s supposed, but options on CID like change dynamic lines, brightness etc are all greyed out, but that is not a huge problem, I can deal with that later. Also, tried to flash ICAM ( it was new ), but got error about ftp and tftp, left it alone for now.
 
The real problem I am getting with TPM malfunction, service engine light on and no Date/Time on instrument cluster and CID.
I didn’t touch KOMBI, but some reason now it is not showing up on the list while reading ECUs. After I do SVT calculation it’s there and with yellow folder while all others are blue/red.
ICAM is yellow as well (could be why options are greed out in PDC options). When tried to reflash KOMBI got an error ‘P2 timeout on Service RDBI_SVK has error in reslult: [Severity=2051]’ resource not available P2 timeout occurred. 
 
Guys, I need your help if that could be fixable and I can get my KOMBI back to answer.
Thank you.