[mikeypx82]

Alternatively, a K+DCAN cable flashed with the ediabaslib firmware (for the Atmega) will fix it as well. The Chinese K+DCANs all have a firmware bug for specific modules.

Or just buy it at bimmergeeks already flashed with fixed firmware.

Do you know where I can get this firmware for my k+dcan cable?

---

The fuses have to be set as follows:
Fuse
Value (hex)Low
0xFD
High
0xDC
Extended
0xF9

Alternatively, a K+DCAN cable flashed with the ediabaslib firmware (for the Atmega) will fix it as well. The Chinese K+DCANs all have a firmware bug for specific modules.

Or just buy it at bimmergeeks already flashed with fixed firmware.

Do you know where I can get this firmware for my k+dcan cable?

I found the firmware and the instructions here:

https://github.com/uholeschak/ediabaslib...are-update 

I ordered an AVR programmer so I can update the firmware. According to the instructions, you are supposed to set the low, high, and extended fuses to 0xFD, 0xDC, and 0xF9. I'm not sure what this means. Can someone explain this? Thanks in advance!