[____ANGEL___]

You have it in emergency mode due to a fan error.
You need to connect the fan and start with icom so that the error is reset. If you continue to use with this error, the icom will stop working and it will be difficult to restore it.

---

Recognizes voltage mega 16.
Check the voltage as I indicated in the photo

---

All ICOM from China A1
To avoid an error on the fan, you need to perform a flashing in ICOM2
The firmware version is determined by the ICOM serial number, in China they are all the same 1120134. To change ICOM2, you need to change the serial number in 24c02 to the serial number from the range 1801201, and then restore the ICOM  from the restore.bin

Do not use serial numbers like 1111111, after restoration you will get a brick!!

hi Ferrum, i don't have xprog eprom adapter so i can't change serial, there is another way to do it? I see here on other thread a pic of icom 60080 page with option for changing e2p data.... please can you explain me more? My icom a2 was with flashing red system light and log with fan failure